Mechanical installation
Notes on mounting the device version in push−through design
Assembly in push−through technique (thermal separation)
5
l
83
EDS700ACBA EN 5.1
Safety instructions for the installation according to UL
If a control cabinet/plant is to be approved according to UL, the following has to be
considered:
ƒ The device version in "push−through design" is made for the installation in the
control cabinet and achieves "Open Type" according to UL508C.
ƒ If the cooling ribs are not inside the control cabinet but stick out of the control
cabinet housing: Prevent direct contact with the cooling ribs.
To Next Page
Loading...
Need help?
General