6 Commissioning
6.3 Setting the station name
28
Lenze · Inverter Drive 8400 motec (PROFINET® option) · DMS 5.0 EN · 02/2019 · TD23
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
In the »Engineer« the station name is set under the Settings tab.
• Then click Accept change. The station name is saved and written to code C13899
.
• In the Lenze setting a deleted name is displayed. The name is also deleted if the "Reset to factory
defaults" command is executed by an IO supervisor or an I/O controller.
To Next Page
Loading...
