Lenze E84DGFCR Series - Parameters Relevant for PROFINET Communication

13 Parameter reference
13.2 Parameters relevant for PROFINET communication
76
Lenze · Inverter Drive 8400 motec (PROFINET® option) · DMS 5.0 EN · 02/2019 · TD23
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
13.2 Parameters relevant for PROFINET communication
This chapter lists the PROFINET parameters of the Communication Unit in numerically ascending
order.
C13000
C13001
 Note!
PROFINET command "Reset to Factory Defaults"
If the "Reset to factory defaults" PROFINET command is executed by an IO supervisor or
an I/O controller, the PROFINET-specific parameters will be reset to their standard
values:
• C13000
| IP address
• C13001
| Subnetwork mask
• C13002
| Gateway address
• C13010
| Active IP address
• C13011
| Active subnetwork mask
• C13012
| Active gateway address
• C13864
| Active station name
• C13887
| Suppress signalling diag. mess. upon
• C13899
| Station name
• C13910
| I&M1 system designation
• C13911
| I&M1 installation site
• C13912
| I&M2 installation date
• C13913
| I&M3 additional information
• C13914
| I&M4 signature code
Parameter | Name:
C13000 | IP address
Data type: UNSIGNED_32
Index: 11575
d
= 2D37
h
Setting of the IP address
Setting the IP configuration
( 29)
Setting range (min. value | unit | max. value) Lenze setting
0 4294967295 0
 Read access  Write access  CINH  PLC-STOP  No transfer  PDO_MAP_RX  PDO_MAP_TX  COM  MOT
Parameter | Name:
C13001 | Subnetwork mask
Data type: UNSIGNED_32
Index: 11574
d
= 2D36
h
Setting of the subnet mask
Setting the IP configuration
( 29)
Setting range (min. value | unit | max. value) Lenze setting
0 4294967295 0
 Read access  Write access  CINH  PLC-STOP  No transfer  PDO_MAP_RX  PDO_MAP_TX  COM  MOT