13 Parameter reference
13.2 Parameters relevant for PROFINET communication
78
Lenze · Inverter Drive 8400 motec (PROFINET® option) · DMS 5.0 EN · 02/2019 · TD23
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
C13011
C13012
C13850
Parameter | Name:
C13011 | Active subnetwork mask
Data type: UNSIGNED_8
Index: 11564
d
= 2D2C
h
Display of the active subnetwork mask
• The active subnetwork mask may differ from the contents of code C13001
, depending on whether the station
name was changed via the fieldbus or the parameter.
Display range (min. value | unit | max. value)
0 255
Subcodes Info
C13011/1 Active subnetwork mask.1
C13011/2 Active subnetwork mask.2
C13011/3 Active subnetwork mask.3
C13011/4 Active subnetwork mask.4
Read access Write access CINH PLC-STOP No transfer PDO_MAP_RX PDO_MAP_TX COM MOT
Parameter | Name:
C13012 | Active gateway address
Data type: UNSIGNED_8
Index: 11563
d
= 2D2B
h
Display of the active gateway address
• The active gateway address may differ from the contents of code C13002
, depending on whether the station
name was changed via the fieldbus or the parameter.
Display range (min. value | unit | max. value)
0 255
Subcodes Info
C13012/1 Active gateway address.1
C13012/2 Active gateway address.2
C13012/3 Active gateway address.3
C13012/4 Active gateway address.4
Read access Write access CINH PLC-STOP No transfer PDO_MAP_RX PDO_MAP_TX COM MOT
Parameter | Name:
C13850 | All words to master
Data type: UNSIGNED_16
Index: 10725
d
= 29E5
h
Display of the process data words which are transmitted from the inverter to the IO controller.
In the subcodes 1 to 8, all process data words to the I/O controller are displayed. However, only the configured
process data words are valid.
Display range (min. value | unit | max. value)
0 65535
Subcodes Info
C13850/1
...
C13850/8
Read access Write access CINH PLC-STOP No transfer PDO_MAP_RX PDO_MAP_TX COM MOT
To Next Page
Loading...
