Lenze ECSES Series - Page 107

Commissioning
Setting of the feedback system for position and speed control
TTL/SinCos encoder as position and speed encoder
6

107
EDBCSXS064 EN 4.0
Codes for feedback system selection
Code Possible settings IMPORTANT
No. Designation Lenze/
{Appl.}
Selection
[C0490] Feedback pos 0
Selection of feedback system for
positioning control
 103
0 Resolver at X7 Standard setting
1 TTL encoder at X8
l Sets C0419 = 0 ("Common") if
a different encoder type as
under C0419 is set here.
2 SinCos encoder at X8
3 Absolute value encoder (single−turn) at
X8
4 Absolute value encoder (multi−turn) at
X8
[C0495] Feedback n 0
Selection of feedback system for
speed control
 103
0 Resolver at X7 Standard setting
1 TTL encoder at X8
l Sets C0419 = 0 ("Common") if
a different encoder type as
under C0419 is set here.
2 SinCos encoder at X8
3 Absolute value encoder (single−turn) at
X8
4 Absolute value encoder (multi−turn) at
X8