Lenze ECSES Series - Commissioning Steps (Overview)

Commissioning
Commissioning steps (overview)
6

94
EDBCSXS064 EN 4.0
6.2 Commissioning steps (overview)
Start
Carry out
basic settings
( 95)
Select
operating mode/control structure
( 126)
Set machine parameters for
speed control
( 141)
Set machine parameters for
torque control
( 141)
l Switch on the mains.
l Enable controller ( 154).
l Save parameters in the controller with
C0003 = 1.
l Save parameter set with GDC in the
parameter set file.
Optimise
drive behaviour
( 154)
l Save parameters in the controller with
C0003 = 1.
l Save parameter set with GDC in the
parameter set file.
End