Configuration
CAN management
8
186
EDBCSXS064 EN 4.0
8.3 CAN management
The function block CAN (CAN management)
ƒ serves to activate a reset node to e.g. accept changes in the transfer rate and
addressing.
ƒ serves to process statuses as Communication Error, Bus Off State, etc.
ƒ the instant of transmission of CAN2_Out and CAN3_Out can be influenced.
ƒ serves to monitor the CAN communication.
Tip!
Detailed information on the FB CAN can be found in the chapter 12.9 ( 267).
Note!
Even if the CAN function block has not been assigned to the control
configuration, a reset node can be carried out via C0358.
To Next Page
Loading...
