Lenze ECSES Series - Page 426

Appendix
Code table
13

426
EDBCSXS064 EN 4.0
IMPORTANTPossible settingsCode
SelectionLenze/
{Appl.}
DesignationNo.
C7530 Display of the current signal
states on the analog input of the
"Torque" function block
−32768
(= −100 %)
{1} 32767
(= 100 %)
1 TorqueIn−anl Torque setpoint
(SPEED-MCTRL.MAdd)
 354
2 TorqueIn−anl Setpoint for the upper limit of
speed limitation
(TORQUE−NSET.NSet)
 351
3 TorqueIn−anl Lower torque limit
(TORQUE-MCTRL.negLoMLim)
 354
4 TorqueIn−anl Upper torque limit
(TORQUE-MCTRL.HiMLim)
5 TorqueIn−anl Setpoint for the lower limit of
speed limitation
(TORQUE−MCTRL.NStartMLim)
6 TorqueIn−anl Manual field weakening
(TORQUE−MCTRL.FldWeak)
7 TorqueIn−anl Manual adaptation of the
proportional gain of the speed
controller
(TORQUE−MCTRL.NAdapt)
8 TorqueIn−anl Manual adaptation of the
integral−action component of the
speed controller
(TORQUE−MCTRL.ISet)
9 TorqueIn−anl Torque threshold for the motor
holding brake
(TORQUE−BRK.TorqueThreshold)
 360
10 TorqueIn−anl Direction of torque created by
the drive against the motor
holding brake
(TORQUE−BRK.Sign)