Lenze EMF2181IB

Commissioning
Commissioning with the system bus configurator
6
l
32
EDSMF2181IB EN 3.0
6.2 Commissioning with the system bus configurator
) Note!
A window−compatible modem must be installed in the windows system
control.
The communication is executed via the TAPI interface.
System requirements
The following minimum requirements of hardware and software must be met to work
with the communication module:
ƒ MicrosoftR WindowsR 2000/XP
ƒ IBMR−compatible PC with IntelRPentiumR−266 processor or higher
ƒ 128 MB main memory with Windows2000/XP
Available Lenze programs
The following Lenze programs allow for a communication via the communication module
:
ƒ Drive Server
ƒ Global Drive Control (GDC version 4.7 or higher)
ƒ Global Drive Loader
ƒ Global Drive PLC Developer Studio (DDS version 1.4 or higher)
ƒ L−force Engineer
) Note!
One of the programs mentioned offer alternative communication paths for
CAN. In this case, please always select the communication path "OPC".