Commissioning
Commissioning with the system bus configurator
6
l
34
EDSMF2181IB EN 3.0
Installation of the diagnostic interface communication
configurator
The diagnostic interface communication configurator is installed together with the
diagnostic interface communication software. It is used if the connection between the
ModemCAN and the inverter is established (¶ 21) via the diagnostic interface instead of
via CAN. (¶ 22) All following notes relating to the system bus configurator also apply to
the diagnostic interface communication configurator.
) Note!
The current version of the CAN communication software is displayed in the
information dialog of the "Diagnostic interface communication configurator"
and other Lenze programs.
To Next Page
Loading...
