Lenze EMF2181IB - Page 74

Appendix
AT commands
Call control commands
10
l
74
EDSMF2181IB EN 3.0
Command: &P
Select pulse dialling mode
make/break ratio
Determines the make/break ratio which is used in pulse dialling mode. The default setting
depends on the country. If it is valid, the parameter value is rewritten to S28 bits 3 and 4.
Command Default
setting
Values defined Result codes
&P 0
&P0 Selects a 39%−61% make/break ratio at 10 pulses per
second.
OK
otherwise ERROR
&P1 Selects a 33%−67% make/break ratio at 10 pulses per
second.
&P2 Selects a 39%−61% make/break ratio at 20 pulses per
second.
&P3 Selects a 33%−67% make/break ratio at 20 pulses per
second.