Lenze Global Drive 8200 vector - LED Status and Fault Reset

Troubleshooting and fault elimination
Error messages
13
L
EDK82EVXXX EN 2.0
LED 3 Operating status
red c green d
off on Controller enabled
on on Mains switched on and automatic start inhibited
off slowly blinking Controller inhibi ted
off fast blinking Motor parameter identification
fast blinking off Undervoltage or overvoltage
slowly blinking off Error active, check under C0161
OFF
20 28
X3
880Hr
01 61
000
1
abcde
j g fkih PS 

mno
p
qr
Hi
Hz
%sh
rpm
°C
Ω
m
AV
Lo
3
1
4
5
2
6
ON
z
y
wx
v
t
u
s
88888
8888
888
8
a bcde
j gfkih PS 
 mno
p
qr
Hi
Hz
%sh
rpm
°C
Ω
m
AV
Lo
82vec355
Reset the drive controller in this way, if a fault occurs (TRIP-Reset):
1. Plug the keypad onto the AIF interface during operation.
2. Read and take down fault message of the keypad display.
3. Inhibit controller.
4. Separate controller from the mains.
5. Carry out a fault analysis and eliminate the faults.
6. Restart the controller.