Lenze i410 - Safety Instructions; Basic Safety Measures and Precautions

5
Safety instrucons
Operang Instrucons i410-Cabinet
1.5 Idencaonoftheproducts
I 4 1 A E xxx x 1 x x x x xxxx
Product type Inverter I
Product family i400 4
Product i410 1
Product generaon Generaon 1 A
Mounng type Control cabinet mounng E
Rated power [W]
(examples)
0.25 kW 125
0.75 kW 175
2.2 kW 222
Mains voltage and
connecon type
1/N/PE AC 230/240 V B
Motor connecons Single axis 1
Integrated funconal
safety
Without 0
Degree of protecon IP20 0
IP20, coated V
Interference suppres-
sion
Without 0
Integrated RFI lter 1
Design types Global type 50 Hz 0
Basic I/O without network 000S
2 Safetyinstrucons
2.1 Basic safety measures
Disregarding the following basic safety measures may lead to severe personal injury and
damage to property!
• The product:
• must only be used as directed.
• must never be commissioned if they display signs of damage.
• must never be technically modied.
• must never be commissioned if they are not fully mounted.
• must never be operated without required covers.
• must only be disconnected from the installaon in de-energized condion.
• Connect/disconnect all pluggable terminals only in de-energized condion.
• Carry out insulaon resistance tests between 24-V control potenal terminals and PE. The
maximum test voltage must not exceed 110 V DC.
The safety measures are the condion for safe and trouble-free operaon and the
achievement of the specied product features.
The procedural notes and circuit details given in this document are suggesons and their
transferability to the respecve applicaon has to be checked. The manufacturer does not
take responsibility for the suitability of the process and circuit proposals.
The product may cause EMC interferences. The operator is responsible for execung the
interference suppression measures.