Lenze i550

Engineering Tools
11 | P a g e L e n z e i 5 5 0 A c t u a t o r S p e e d A O I
1 Setup
1.3.1 EDS Installation in RSLogix 5000
1.3.2 Add i550 Drive to Project and Required Settings for AOI Control
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Figure 8: Confirm registration
You are now ready to add your i550 to your project.
NOTE: If there is a newer edition of the EDS file, consult Section 3 of this document, EDS File
Revisions, on how to properly implement it. Otherwise you will get a “false data type” error.
1.3.2 Add i550 Drive to Project and Required Settings for AOI Control
1) Add i550 drive as New Module to the Ethernet network. Select catalog number 2017-
03-07-i550 from module list (Figures 9, 10).