Lenze i550 - Additional Functions (Group 7)

Operating instructions i550 cabinet frequency inverter | 42
© 11/2021 · EN · www.Lenze.com
Display code Name Possible settings Keypad code Information
P700.01 Load default settings
On / start [1]
1 = reset all parameters in the RAM memory of the inverter to the default setting stored in the inverter rmware.
• All parameter changes made by the user are lost during this process!
• This process may take some seconds. When the device command has been executed successfully, the value 0 is
shown.
• Loading parameters has a direct eect on cyclic communication: The data exchange for control is interrupted and a
communication error is generated.
O/ready [0] Only status feedback
P700.03 Save user data
On / start [1]
1 = save current parameter settings in the user memory of the memory module with mains failure protection.
• This process may take some seconds. When the device command has been executed successfully, the value 0 is
shown.
• Do not switch o the supply voltage during the saving process and do not unplug the memory module from the
inverter!
• When the inverter is switched on, all parameters are automatically loaded from the user memory of the memory
module to the RAM memory of the inverter.
O/ready [0] Only status feedback
Additional functions (group 7)
Commissioning









Parameter overviewTerminal controlKeypad controlImportant notesInitial switch-on
Extended
terminal control
Keypad module
Additional functions
Basic setting Motor control
Favorites