LERICA C310 - Operation; Control Panel Functions and Warnings

92
EN
USER
Rev. 03 - 07/2015 - Cod. 1501151 - Instruction manual for vacuum chamber packaging machines Mod. C254-C308-C312-C412-C420




-



Thefactorysettingsthatappearupontherststart-uparedescribedbelow.Thesevaluescanbechangedor
integratedviaprogramming,inwhichcasetheyareoverwritten.
FUNCTION VALUES
VACUUM 99
ADDITIONAL VACUUM 5 sec
SEALING 3,5 sec
GAS INJECTION
off (OFF)
withthemachineon,presstheUP and DOWNkeysatthesame
timefor4”.





WhenallLEDSareonandOILshowsonthedisplay,thismeansthemaximumnumberofcycleshasbeen
reachedandthepumpoilmustbechanged.
Thecyclesmustberesetbyanauthorisedafter-salescentreoncethepumpoilhasbeenreplaced.

Torecalltheexactnumberofcyclesperformedbythemachine,pressSTOP for4”.

Ifoverheatingoccurs,thefunctionsareblockedandthedisplayshowsALL.



FUNCTION VALUES
VACUUM 0 - 99
ADDITIONAL VACUUM 0 - 60 sec
SEALING 0,1 - 10 sec
GAS INJECTION 0 - 60 sec