95
4. Why can I not connect to the Internet even though the cables are plugged in WAN port and
LAN port and the LEDs are blink? In addition, the Status LED is also normal and I can
configure the web management?
A: Make sure that the network cable from DSL or Cable modem is plugged in WAN port of Router
and that the network cable from LAN port of router is plugged in Ethernet adapter. Then, please
check which WAN type you use. If you are not sure, please call the ISP. Then please go to this
page to input the information given to you by your ISP.
5. When I use Static IP Address to connect to the Internet, I can access or ping global IP
addresses such as 202.93.91.218. However, I cannot access the a website by using its
domain name, for example http://espn.com ?
A: Please check the DNS configuration of Static IP Address. Please refer to the information of ISP
and assign one or two DNS servers.
To Next Page
Loading...
