LEVIT E-bikes - E-bike Battery Management; Battery Recommendations and Warnings; Battery Lock and Safety Precautions

13
Baery
Recommendation
Battery is the most expensive part of the whole e-bike. Therefore, it is advisable to pay
maximum attention to its recharging, storage and manipulation. The battery contains certain
chemicals that may be dangerous if the battery is handled or used incorrectly. Be careful,
lithium and its oxides are flammable in contact with humidity.
Never dismantle the battery. Use of incorrect procedure might easily damage it. At the
same time, there is a risk of injury due to ignition or possible explosion. Bear in mind that
tampering and disturbance of the warranty seal results in warranty for the battery and all its
parts becoming invalid.
WARNING If the baery capacity is too low, the motor will cease to run smoothly and will
show irregularities in its operation. In such a case, switch of the electric drive system and
continue without its assistance as if you are riding a regular bike. Baery being hot is a
normal feature, and is not indicative of any fault. The baery is protected by a temperature
sensor that will disable it automatically if it is overheated (e.g. when the ambient
temperature is too high). Wait until the baery cools down to the operation temperature and
then resume your ride.
WARNING The power of the motor decreases as the baery charge level decreases.This
means that it can provide half of its original power if the baery has a 30% charge. This may
change depending on the motor type.
Baery lock
Always lock the baery and take the lock with you whenever you leave your
e-bike unaended at a public place. This will prevent the of the baery.
Keep the baery always locked while riding! The baery lock does not serve
as a mere protection of the baery from being stolen, but ensures its safe
position. Baeries without rocker switches are switched o automatically aer 30 minutes
of inactivity (the time may dier depending on baery type). The baery is not capable of
detecting low consumption of energy by the display, and so it may happen, that the baery
(and the whole system with it) is switched o automatically during a long unassisted ride. You
can prevent this from happening by activating the assistance for a short period of time.
ATTENTION Always switch the baery o before manipulating with it.