LEVIT E-bikes - TFT Control System Features; Display Management and Data Operations; Parameter Settings and Error Information

8
WARNING Do not try to hinder the bicycle motion. In such case, the motor may suer
damage.
Changing the speed and distance indicator modes
The change of information displayed is carried out by a short pushing of the buon I.
Switching on/off the display backlight
The display backlight is switched on/o by pushing the (+) buon and holding it pushed for 2
seconds. The display backlight is turned on automatically in low light. If it is disabled automatically,
it must be reactivated manually. The backlight intensity can be adjusted by the user – see the
parameters seing below.This sequence will turn on or o the front/rear lights of Tour models.
Deletion of temporary data
Use the method described in the paragraph on parameters seings to delete temporary data.
The temporary data can be deleted via “Display seing” and “TRIP reset” (once the TRIP reset
item is highlighted, push the (+) buon, and set to “YES” value using (+) (-) buons. Aer you have
confirmed your selection by the I buon, the temporary data will be deleted. The temporary data
will also be deleted automatically aer reaching the ride time of 99:59 hours. The temporary data
will not be deleted in case the display is switched o.
Setting of parameters
Push the I buon twice in the space of approximately 0.3 seconds to enter the parameter seing
mode. Use the (+) (-) buon to navigate through individual menu items and to change seing of
parameters. Push the I buon to confirm your selection. push the I buon twice in the space of
approximately 0.3 seconds to exit the parameter seing mode. The parameters seing mode will
be disabled automatically aer 10 seconds of inactivity.
Display Setting Unit item
Information item
Items in the seings may dier based on the display soware version currently used.
TRIP
Distance of
your trip
ODO
Total
distance
MAX
Maximum
speed
AVG
Average
speed
RANGE
Remaining
range
TIME
Total
ride time
Unit – seing of units (km / miles)
Brightness – seing of display backlight intensity (10, 30, 50, 75 or 100%)
Auto Off – sets the automatic display switching o (1–9 min)
Max Pas – seing of number of assists (3/5/9)
Power View – seing of power indicator format (power / torque)
SOC View – baery status indicator format seing (percentage/voltage)
TRIP reset – deletion of temporary data (TRIP, MAX, AVG, TIME)
AL Sensitivity – lighting sensitivity (0 – 5.0 = light sensor switched o)
Set Clock – clock seing
Back – return
Battery info – complete information about the baery status and features
Error Code – complete information about error messages displayed (max. 10 items)
Back – zpět