EN
13
then it needs to be replaced. Extra pads are
To maintain the performance of your
only
Customer Support (see page 18).
Cleaning the Aroma Pad
Replacing the Aroma Pad
1. Pull out the aroma box and remove the
aroma pad. [
Figure 4.1
]
2. Rinse the pad under warm, running
water. [
Figure 8.1
]
3.
4. Place the aroma pad back into the aroma
box. [
Figure 8.2
]
Note:
Do not
Reassembling
1.
[
Figure 9.1
]
2. Replace the mist tube on the water inlet
tank. [
Figure 9.2
]
3.
[
Figure 6.4
]
4. Place the water inlet tank in the
cover.
Replacing the Remote Control
Battery
1.
page 12) and allow all parts to dry
completely before storing.
2. Wrap the power cord around the cable
winder.
3. Store in a cool, dry location.
1. Remove the battery compartment by
pinching the tab in and pulling the
compartment out. [
Figure 10.1
]
2. Remove the old battery
3. Replace with a new 3V CR2025 battery.
Make sure the polarities match.
4. Replace the battery compartment.
Storing
8.
Soak for 1 hour. [
Figure 7.6
]
9. Rinse all parts until any vinegar smell is
completely gone. [
Figure 7.7
]
5.
water tank.
6.
To Next Page
Loading...
