To Next Page

To Previous Page

Sleep Mode

Sleep Mode uses the lowest possible fan speed to operate quietly.

Tap to turn Sleep Mode on/off.

Tapping or will also exit Sleep Mode.

Air Quality Indicator

This indicator uses an automatic sensor to display the air quality.

Air Quality Indicator Chart

Indicator Colour Air Quality Fan Speed

Blue Very Good Sleep Mode

Green Good Low

Orange Moderate Medium

Red Bad High

PM2.5 Value & Air Quality

The PM2.5 value on the display shows the amount of particles (µg) that are detected within 1 cubic metre (m³).

PM2.5 refers to particulate matter (PM) that is less than or equal to 2.5 micrometres (µm) in diameter. These particles, also known as “fine particles”, are so small that they can only be

detected with an electron microscope, and stay in the air longer than heavier air particles such as dust and pollen.

Your air purifier is equipped with a laser dust sensor that detects the amount of PM2.5 particles that are in a given space (µg/m³). Generally, the lower the number, the better your air quality.

A number above 135 indicates that there is an unhealthy amount of fine particles in the air.

Timer

You can set a timer between 1– 12 hours.

1. Tap repeatedly (or press and hold ) to set a time.

2. Once you choose a time, the timer will flash 5 times and start counting down.

3. The air purifier will automatically turn off once the timer is finished.

4. To cancel a timer, tap repeatedly until the timer reads “- – – -”. The timer will flash 5 times to confirm cancellation.

Note:

You can change the fan speed at any time while the timer is counting down. The timer will work with any mode.

Pressing or unplugging the air purifier will cancel the timer

Memory Function

The air purifier will remember its programmed settings when turned off, and will resume these settings when it is turned back on. The air purifier must remain plugged in for the memory

function to work.

Note: The air purifier will not remember timers.

About the Filter

The True HEPA Combination Filter uses a 3-stage filtration system to purify air.

A. Nylon Pre-Filter

Captures large particles such as dust, lint, fibres, hair, and pet fur.

Maximises the life of the True HEPA Filter by protecting it.

B. H13 True HEPA Filter

Captures at least 99.97% of airborne particles 0.3 microns (µm) in size.

Filters small particles such as mould spores, fine dust, smoke particles, bacteria and viruses*, and allergens such as pollen, dust mites, and pet dander.

C. Custom High-Efficiency Activated Carbon Filter