12
CARE & MAINTENANCE
Cleaning the Air Purifier Check Filter Indicator
Resetting the Check Filter
Indicator
Cleaning the Sensor Cover
will light up as a reminder to check
the filter. Depending on how often you use
the air purifier, the indicator should turn on
within 6–8 months. You may not need to
replace your filter yet, but you should check
it when turns on.
Reset the Check Filter Indicator when:
If the air quality indicator does not seem to
be accurate, clean the sensor cover.
1. Unplug before cleaning.
2. Wipe the outside of the air purifier with
a soft, dry cloth. If necessary, wipe
the housing with a damp cloth, then
immediately dry.
3. Vacuum the inside of the air purifier.
1. Remove the sensor cover. [Figure 2.1]
2. Wipe the cover with a dry cloth. Wash
the sponge with clean water, then dry.
3. Replace the sponge into the sensor
cover, and then replace the sensor
cover.
Note: The sensor cover has a sponge inside to
protect the air quality sensor from large particles.
Note: Do not throw away the sponge. If the
sponge is not in the sensor cover, the air quality
sensor may not work correctly.
Note: Do not clean with abrasive chemicals or
flammable cleaning agents.
Figure 2.1
• lights up.
1. Replace the filter (see page 14).
2. Turn on the air purifier.
3. Press and hold for 3 seconds.
4. The light will turn o after the filter
indicator is successfully reset.
• The filter was changed before lit up.
1. Press and hold for 3 seconds
until lights up.
2. Press and hold again for 3
seconds.
3. The light will turn o after the filter
indicator is successfully reset.
To Next Page
Loading...
Need help?
General
