Lexicon
300L Owner's Manual
8-4
Error/Status Messages
Under the described conditions, the following messages will appear on the upper
display of the LARC. In some cases, the display may flash briefly as it is
overwritten with other error/status messages.
!BAD DIGITAL WORD CLOCK! Digital input has been selected, but no valid digital input has been detected. Check the
digital connector setting and check that your digital source is connected and working.
BOGUS CONFIG An invalid audio routing configuration was recognized during an attempted Setup load via
MIDI.
BOGUS EFFECT One of the effects contained in a Setup being loaded via MIDI is invalid for the specified
configuration.
CAN’T LOAD: REG IS EMPTY An attempt was made to load an empty user register.
CAN’T LOAD IN CONFIG! An attempt was made to load an effect which is invalid in the currently specified audio
routing configuration. For example, an attempt to load LARGE HALL (which requires the
Single configuration) into a Cascade Setup, would initiate this message.
EMPTY REG A request was made to load a Setup or Effect register which has nothing stored in it.
MAPTABLE OFF Automation is set to Program Change mode, but the MIDI Map Table is off.
MIDI ERROR An error occurred during MIDI transmission or reception. (This message may occur even
when the unit is operating properly. For example, with Program Change Automation
enabled, the 300L will attempt to transmit effects that are not mapped if the Setup is
mapped. In this instance, the Setup will load properly and this message will be displayed.)
NO BANK REGS MATCH CONFIG An attempt was made to investigate an empty bank, or a bank whose registers are all
invalid for the current configuration.
NOT IN FIXED Program change messages outside MIDI range (>128) were received while Automation
was set to Program Change mode and the MIDI Map Table was set to Fixed.
PGM OFF MAP Program change messages which are not in the map were received while Automation
was set to Program Change mode and the MIDI Map Table was set to Map.
STORE/COPY DISABLED An attempt was made to store, copy or load with the store/copy functions disabled.
STORE EFFECT FIRST An attempt was made to store a Setup containing modified Effects, but no effect registers
were “available”.
Each Setup contains a reference to one (Single) or two (Dual Mono and Cascade) effects.
When you store a setup whose effect(s) have been edited, the 300L tries to automatically
store the edited effects into “available” registers, changing the effect name so the last
characters show the “containing” setup. If there are no “available” effect registers, this
message is displayed. To continue, you must explicitly sore the effect(s) (by overwriting
previously used effect registers), then store the setup.
TIMECODE DISABLED Event List Snap mode was requested with time code disabled.
VAL: LOAD PROG MID RT or SPR has been assigned a target value in an Event Edit List, but there is a
mismatch between the current program location and the location pointed to by the glide.
As all glide requests point to a previous Setup or event triggered in the list, use the Edit
slider to move back through the list until you identify the most recent setup or program
load. Note the location (the Setup number, or the Bank and program number), return to
Setup or Program mode, and load that location. Return to Control mode and finish the
Event List.
To Next Page
Loading...
