Lexicon
300L Owner's Manual
4-16
Σ Σ
Σ Σ
Level
Sample
RFS Balance Rotate
L Delay
L/R Dly
R Delay
Equalizer
LFF
RFF
L Fine
R Fine
LFB
RFB
BAS
TBL
DEMP
SPC
SHUF
TBR
BXO
TXO
TXLR
Stereo Adjust
General Description
The Stereo Adjust algorithm offers fine adjustments of level and equalization
during digital mastering. Its stereo digital fader permits 0.25dB trimming and
provides full fades to digital zero at the end of a track. Its two sets of shelving
treble EQ can be set for different 3dB points and gains. BAS and SPEQ permit
adjustment of stereo width, enhancing the spaciousness and depth of the
recording.
LVL (Master Level)
Stereo Adjust Page One
LVL is a stereo level control, with both channels equally attenuated or boosted.
From -12 to +12dB the fader moves in .25 dB increments. Below -12dB it moves
in .50 dB increments. Below -60 dB the calibration comes in larger steps, finally
dropping to zero output at -72 dB.
PAGE ONE
LVL BAL ROT BAS TRB SPEQ
OFF,-72.00DB TO +12.00DB L+3 TO R+3 L+3 TO R+3 CUT, -18 TO +6DB CUT, -18 TO +6DBCUT, -6.00 TO +6.00DB
PAGE TWO
DLY BXO TXO TXLR TBL TBR
0-5000MS 0.1-26.5KHZ 0.1-26.5KHZ 0.1-26.5KHZ CUT, -18DB - +6DBCUT, -18DB - +6DB
PAGE THREE
SAM DEMP RFS DC DCL DCR
OFF, ON OFF, ON +L+R,+L-R,+R+L,-R+LRESET, MANUAL, AUTO-99 TO +99% -99 TO +99%
PAGE FOUR
LDL LFB RDL RFB - SHUF
0-5000MS -99 TO +99% 0-5000MS -99 TO +99% - 0-10
PAGE FIVE
LFD* LFF RFD* RFF
0-10.417MS -99 TO +99% 0-10.417MS -99 TO +99%
* Parameter ranges are dependent on setting of Sample Rate.
Stereo Adjust
Parameters
To Next Page
Loading...
