Lexicon 300L - REV 1 - Default Chapter; Table of Contents

Contents
Introduction
1. Installing the 300L
Mounting ............................................................................................. 1-2
Power Requirements .......................................................................... 1-2
The Rear Panel .................................................................................. 1-3
Connectors, Cables and Configurations ............................................. 1-4
About the LARC.................................................................................. 1-6
How to Interface the LARC ................................................................. 1-7
Setting Analog Audio Levels............................................................... 1-8
Configurations .................................................................................. 1-10
2. System Overview
Terms used in this manual ................................................................. 2-2
Operating Modes ................................................................................ 2-4
Checking your System's Status .......................................................... 2-5
System Overview................................................................................ 2-6
3. System Operation
Getting Started ................................................................................... 3-2
SoftSlider...................................................................................... 3-3
Selecting Analog and/or Digital Input ........................................... 3-4
Single Setups ..................................................................................... 3-5
Dual Mono Setups .............................................................................. 3-6
Cascade Setups ................................................................................. 3-8
Setup Select Mode ........................................................................... 3-10
The Setup Presets ..................................................................... 3-10
Setup Select ..................................................................................... 3-13
Storing a Setup ................................................................................. 3-16
Working with the Effect Programs .................................................... 3-17
Storing Individual Effect Registers ............................................. 3-19
Automatic Storing of Modified Effects ........................................ 3-20
Using Banks and Programs .............................................................. 3-21
MIDI/Modulation Patching ................................................................ 3-27
Control Mode .................................................................................... 3-28
Analog and Digital Audio Selection ............................................ 3-28
Emphasis and SCMS ................................................................. 3-29
Copy (Enable/Disable, Bypass/Mute, Program Load,
Memory Purge ..................................................................... 3-30
Offline Copy Tools...................................................................... 3-30
MIDI: Automation, Dumps and Channel Selection ..................... 3-31
MIDI: Maps ................................................................................. 3-31
Time Code: Snap and View ....................................................... 3-32
Time Code: Event List and Time Code Edit/Add/Delete ............ 3-32
Input/Output Gains ..................................................................... 3-33