10-3
Specifications
Analog Input to Analog
Output (48kHz sampling rate)
48kHz sample rate: 10Hz tp 21.5kHz, +0.2dB
80dB maximum, 10Hz to 20kHz
90dB minimum, A-weighted
0.01% maximum, 10Hz to 20kHz
0.01% maximum
90dB minimum
Frequency Response
Crosstalk
Signal-to-Noise Ratio
Total Harmonic Distortion
SMPTE Intermodulation
Distortion
Balanced female XLR digital input; Balanced male XLR digital output
Conforms to AES 3-1992 (ANSI S4.40-1992).
Both input and output are transformer-coupled.
Input/output levels and impedance comply with CCITT V.11 and EIA RS-422A.
Unbalanced coaxial "RCA" type digital input and output; SPDIF compatible
Optical (fiber optic) type digital input and output
Master: 48kHz
+5Hz Slave: 42 kHz to 50kHz
44.1 kHz +5Hz
Digital Audio Interfaces
Sample Frequency
Balanced female XLR, EIA-422 input, 100mV p-p minimum. Formats supported::
Speed Range
SMPTE 0.75 to 1.18
(Drop or Non-drop)
EBU 0.80 to 1.33
Film 0.82 to 1.33
5-pin DIN connectors provided for MIDI IN, MIDI OUT, and MIDI THRU
Control Interfaces
Time Code Input
Dynamic Range
AES/EBU
professional digital
audio interface
EIAJ CP-340/SPDIF
consumer digital
audio interface
MIDI Interface
Four mode-select buttons (BANK, PROG, SETUP, REG) used with ten numeric select
buttons (1 to 0); a page select button (PAGE); a load key (ENTER); a control program key
(CTRL); a machine-select key (MACH); two auxiliary control buttons (MUTE, STO); six
sliders for smoothcontrol of up to 128 parameters per program with associated display-
select buttons
Two lines of 12 alphanumeric LEDs for interactive display; additional line of 24 alphanu-
meric LEDs (sixgroups of four for each slider); dual 16-position LED headroom indicator
(calibrated -24 to +12 dBm with overload warning)
DE9
50-ft extra-flexible cable; cables can be linked
Up to 100 feet when powered from mainframe; up to1000 feet possible with optional
remote power source for LARC
LARC
(Lexicon Alphanumeric
Remote Control)
Controls
Display
Connector Type
Cable
Operating Distance
To Next Page
Loading...
