Lexicon
300L Owner's Manual
4-10
PAGE ONE
RT* RVL SIZ ROL DIF PDLY**
.24-64.17SEC OFF, -48TO-1DB, UP FULL 4.0-39.4M 0.5KHZ-21.2KHZ 0-99 0-99.877MS
PAGE TWO
SPN WAN DDLY
0-48 0µS-37.1MS 0-99.877MS
* Parameter range is dependent on setting of SIZ.
** Parameter range is dependent on setting of Sample Rate.
Random Ambience
Parameters
RVL (Reverb Level)
RT (Reverb Time)
SIZ (Size)
ROL (Hi Freq Rolloff)
Random Ambience Page One
This control adjusts the reverberation time of the independent reverberator. The
range of action is limited. Be careful — both long and short reverb times may
sound unnatural. If a much longer or shorter reverb time than the preset provides
is desired, SIZ should be changed first.
RVL sets the amount of reverberation in the processed signal. It should normally
be set between -6 and -12dB.
SIZ allows you to vary the apparent size of the space over a wide range. SIZ is
the most dramatic control, and must be selected to match the music or program
material. It should be the first control that you adjust to tailor the desired space.
SIZ also affects the reverb time, in a similar way to the standard reverb programs.
ROL sets the frequency above which a 6 dB/octave low-pass filter attenuates the
processed signal. High frequencies are often rolled off with this parameter,
resulting in a more natural sounding acoustic space.
L
R
D Delay
Σ
Σ
Ambience Generator
Diffusion Predelay
D Delay
Rolloff
SIZ RTM
SPN WAN
RLVL
To Next Page
Loading...
