Lexicon MC-12HD - Page 96

Setup Lexicon
3-54
AUTOMATIC CALIBRATION (continued)
STEP
DISTANCES
DISTANCES & LEVELS LEVELS
5
FRONT LEFT
OK
Refer to the table on page
3-56 for information about
all possible speaker calibra-
tion messages.
FRONT LEFT
OK
Refer to the table on page
3-56 for information about
all possible speaker calibra-
tion messages.
If there was a DISTANCES calibration
error, an AUTO DISTANCES menu auto-
matically displays.
• A parameter value indicates that no
errors occurred during the calibration
procedure.
• An ERROR message indicates that a value
was calculated, but at least one error
occurred during the calibration proce-
dure.
• Press the  or  arrow button to high-
light the speaker calibration parameter
you want. Then, press the  button to
view more detailed results for the
selected speaker. A message similar to
the one shown above will display.
• Refer to the table on page 3-56 for infor-
mation about all possible speaker calibra-
tion messages.
When the MC-12HD is finished calibrating
speaker distances and output levels, the
AUTO SPEAKER SETUP screen displays,
indicating the results for each calibration
procedure.
• An OK message indicates that no errors
occurred for that group of measure-
ments during the calibration procedure.
• An ERROR message indicates that values
were calculated, but at least one error
occurred during calibration.
• Press the  or  arrow button to high-
light the desired calibration procedure.
DISTANCES displays the AUTO DIS-
TANCES screen shown in the left column
of this table.
LEVELS displays the AUTO LEVELS screen
shown in the right column of this table.
• Press the  arrow button to select this
procedure.
• Refer to the instructions in the appropri-
ate column to view more detailed results
for each individual speaker.
If there was a LEVELS calibration error, an
AUTO LEVELS menu automatically dis-
plays.
• A parameter value indicates that no
errors occurred during the calibration
procedure.
• An ERROR message indicates that a value
was calculated, but at least one error
occurred during the calibration proce-
dure.
•Press the or  arrow button to high-
light the desired speaker calibration
parameter. Then, press the  arrow
button to view more detailed results for
the selected speaker. A message similar
to the one shown above displays.
• Refer to the table on page 3-56 for infor-
mation about all possible speaker calibra-
tion messages.
AUTO SPEAKER SETUP
DISTANCES
LEVELS
AUTO VALUES APPLIED
PRESS TO VIEW
DETAILS
OK
ERROR
AUTO LEVELS
FRONT LEFT
CENTER
FRONT RIGHT
SIDE RIGHT
REAR RIGHT
REAR LEFT
SIDE LEFT
MONO SUB
SUB RIGHT
LFE
-2.0dB
ERROR
-2.0dB
-4.5dB
-3.0dB
-3.0dB
-4.5dB
N/A
N/A
N/A
AUTO DISTANCES
FRONT LEFT
CENTER
FRONT RIGHT
SIDE RIGHT
REAR RIGHT
REAR LEFT
SIDE LEFT
MONO SUB
SUB RIGHT
LFE
12.0ft
10.5ft
12.0ft
4.5ft
ERROR
6.0ft
4.5ft
N/A
N/A
N/A