Getting Started
MPX 110
1-11
REINITIALIZATION
The procedure below outlines the process to reinitialize
the unit. When reinitialized, the unit will restore all
System Mode parameters to their factory-default
settings; replace all User programs with factory-default
presets; and clear all Learned Patches.
To reinitialize the unit:
1. While powering the unit on, press and hold the front
panel Store button until the Store and Tap LEDs flash
quickly.
2. To reinitialize the unit, press the Store button. To
cancel reinitialization without affecting the unit,
press either the Tap or Bypass button.
3. After reinitialization, restart the unit - power it off,
then on again.
Note:
Reinitialization will cause the unit to:
• Restore all System Mode parameters to their
factory-default settings.
• Replace all User programs with factory-default
presets. (See the table on page 4-38.)
• Clear all Learned Patches.
To Next Page
Loading...
