Selecting a Tractor mode
Note: Because this function unloads continuous forms from the currently selected tractor, tear off excess paper prior
to initiating.
When the optional Tractor 2 Feeder is installed, you can press Tractor to unload the current continuous forms and
switch to the continuous forms loaded in the other tractor source.
The Tractor 2 light comes on when the optional Tractor 2 Feeder is selected.
Selecting and locking a font
The printer data stream may contain control codes which select a particular font. To override the codes, you can
select and lock a particular font of your choice.
1 To select a font, press Font repeatedly until you see the font light on next to the selection you want.
2 Continue pressing Font until the Font Lock light comes on, and the font you want is selected.
The font is locked until the printer is turned off.
Disabling Font Lock
1 To disable Font Lock, press Font repeatedly until the Font Lock light turns off and the font you want is selected.
2 If the printer is offline, press Start/Stop.
The printer is ready to print when the Ready light comes on.
Using the control panel
21
To Next Page
Loading...
