Interface options
Note: Use Setup mode to configure the printer according to your needs. To print a list of all default settings, press
LineFeed from the Main menu.
The following list items outline and explain the Interface options and settings you can use with the printer:
Interface Selection
Unless turned off, the Auto setting automatically selects the printer interface from the available connection cables.
The following connection cables are available: parallel cable, USB cable, serial cable (only available when an optional
serial interface is installed), and network cable (only available on network models).
Note: Auto is the factory default setting.
Honor Init.
• Enabled—Honors the initialization signal on the parallel port
• Disabled—Ignores the initialization signal on the parallel port
Note: Enabled is the factory default setting.
Understanding Setup mode and menu options
56
To Next Page
Loading...
