Lexmark 2500 - Converting the Pull Tractor to Push Tractor Position

8 To slide the tractor feeder into the printer:
a Hold down the latching levers and gently push the tractor feeder into the printer until it stops.
b Continue holding down the latching levers, and tilt the tractor feeder toward the front of the printer until the
hooks at the end of the latching levers fit around the posts on the printer frame.
c Release the latching levers.
Note: The tractor unit fits into place at a 40° angle.
Converting the pull tractor to push tractor position
1 Make sure the printer is off.
2 Make sure paper is not loaded in the printer.
3 Hold down the latching levers while you lift and pull the tractor unit out of the printer.
4 Pull the front cover up and out of the way.
Changing tractor positions
46