Loading cut forms
Cut forms can be single sheets, envelopes, or multiple-part forms. They are placed one at a time into the manual
feeder.
Loading a cut form or envelope manually
Note: If you have installed the optional Auto Sheet Feeder or Tractor 2 Feeder, see the documentation that came
with the option, for paper loading instructions.
1 Turn the printer on.
2 Make sure the paper path is clear.
3 If continuous forms are currently loaded, tear off the leading edge of the continuous form, and then press
Load/Unload to park the continuous forms.
The Paper Out light blinks.
4 Set the forms thickness lever to a corresponding setting for the type of paper you are using.
5 Move the paper select lever up to the position.
6 Open the manual feeder.
Loading paper
37
To Next Page
Loading...
