Buffer
• Minimum—Sets the receive buffer size to zero
• Maximum—For 2580/2581 models, sets the receive buffer size to 64KB or 480KB, depending on whether NLQ II
(Near Letter Quality) Download is enabled
• Maximum—For 2590/2591 models, sets the receive buffer size to 47.5KB or 480KB, depending on whether
Download is enabled
Note: Maximum is the factory default setting.
Auto LF
Requires a line feed to occur.
• On—A line feed is performed for each Carrier Return (CR) code received.
• Off—A line feed does not occur when a CR code is received.
Note: Off is the factory default setting.
Auto CR
Requires a CR to occur.
• On—A CR is performed for each line feed code received.
• Off—A CR does not occur when a line feed code is received.
Note: Off is the factory default setting.
Zero Slash
• On—The zero (0) prints with a slash down the middle.
• Off—The zero (0) prints without a slash down the middle.
Note: Off is the factory default setting.
Download to NLQ II (available for 2580/2581 models only)
• Enabled—Reserves a portion of the receive buffer for downloading fonts
• Disabled—Uses the entire buffer as a receive buffer
Note: Enabled is the factory default setting.
Download (available for 2590/2591 models only)
• Enabled—Reserves a portion of the receive buffer for downloading fonts
• Disabled—Uses the entire buffer as a receive buffer
Note: Enabled is the factory default setting.
Code Page Sub.
• Enabled—Substitutes code page 858 for 850 to allow older programs access to the European characters
• Disabled—No code page substitution
Note: Disabled is the factory default setting.
Understanding Setup mode and menu options
53
To Next Page
Loading...
