Control options
Note: Use Setup mode to configure the printer according to your needs. To print a list of all default settings, press
LineFeed from the Main menu.
The following list items outline and explain the Control options and settings you can use with the printer:
Uni-Dir Printing
• On—The printer prints unidirectionally by line (in NLQ mode).
• Off—The printer prints one line and a return line of print bidirectionally. Proportional Spacing is an exception;
when this pitch is selected, the printer still prints unidirectionally.
Note: Off is the factory default setting.
Auto Ready Cut Sheet
Customizes how the printer goes to the Ready state after a cut sheet is loaded.
• On—The printer automatically goes to the Ready state after a cut sheet is loaded.
• Off—The printer remains offline after a cut sheet is loaded. Press Start/Stop to return the printer to the Ready
state.
Note: On is the factory default setting.
Paper Out Alarm
• Enabled—An alarm sounds when the printer runs out of paper.
• Disabled—No alarm sounds when the printer runs out of paper.
Note: Enabled is the factory default setting.
Demo Print
• Enabled—Prints a Demo page
• Disabled—Does not print a Demo page
Note: Enabled is the factory default setting.
Menu Language
Select the language you want the menus to print in. Available languages are: English, French, German, Italian, Spanish,
and Brazilian Portuguese.
Note: English is the factory default setting.
TOF Read
• Enabled—Verifies the Top-Of-Form before printing begins on continuous forms
• Disabled—Does not verify the Top-Of-Form before printing on continuous forms
Note: Enabled is the factory default setting.
Understanding Setup mode and menu options
54
To Next Page
Loading...
