Selecting and locking a pitch
The printer data stream may contain control codes which select a particular pitch. To override the codes, you can
select and lock a particular pitch of your choice.
1 To select a pitch, open the control panel to layer 2.
2 Press Pitch repeatedly until the pitch light comes on next to the pitch you want.
3 Continue pressing Pitch until the Pitch Lock light comes on and the pitch you want is selected.
The pitch is locked until the printer is turned off.
Disabling Pitch Lock
1 To disable Pitch Lock, press Pitch repeatedly until the Pitch Lock light turns off and the pitch you want is selected.
2 Close the control panel.
3 If the printer is offline, press Start/Stop.
When the Ready light comes on, the printer is ready to print.
Using the control panel
22
To Next Page
Loading...
