Administrative support
Restoring the factory default settings
Restoring the US factory default settings
The factory default settings for the United States are:
• Code pages: 437
• Character Set: 1
• Form length: 11 inches
To restore the factory default settings:
1 Make sure the ribbon cartridge is installed and paper is loaded.
2 Turn the printer off.
3 Open the ribbon access cover.
4 Move the printhead over toward the control panel side of the printer until it stops.
5 Close the ribbon access cover.
6 Press and hold Tear Off and Load/Unload while turning the printer on.
7 Continue holding the buttons until the carrier moves.
Note: The control panel lights blink on and off several times.
The factory default settings have been restored once the carrier moves.
Restoring the EU factory default settings
The factory default settings for Europe are:
• Code pages: 858
• Character Set: 2
• Form length: 12 inches
To restore the factory default settings:
1 Make sure the ribbon cartridge is installed and paper is loaded.
2 Turn the printer off.
3 Open the ribbon access cover.
4 Move the printhead over toward the control panel side of the printer until it stops.
5 Close the ribbon access cover.
6 Press and hold Tear Off and Tractor while turning the printer on.
7 Continue holding the buttons until the carrier moves.
Note: The control panel lights blink on and off several times.
Administrative support
59
To Next Page
Loading...
