Menu item Description
Configure Log
Enable Audit
Yes
No
Enable Remote Syslog
Yes
No
Remote Syslog Facility
0‑23
Severity of events to log
0‑7
Specifies whether and how the audit logs are created
Notes:
• Enable audit determines if events are recorded in the secure audit log and
remote syslog. No is the factory default setting.
• Enable remote syslog determines if logs are being sent to a remote server. No
is the factory default setting.
• Remote syslog facility determines the value used to send logs to the remote
syslog server. 4 is the factory default setting.
• With the security audit log activated, the severity value of each event is
recorded. 4 is the factory default setting.
Set Date/Time menu
Menu item Description
View Date/Time Lets you view the current date and time settings for the printer
Set Date/Time
<input date/time>
Note: Date/Time is set in YYYY-MM-DD HH:MM format.
Time Zone
<list of time zones>
Note: GMT is the factory default setting.
Observe DST
On
Off
Note: On is the factory default setting and uses the applicable Daylight Saving Time
associated with the Time Zone setting.
Enable NTP
On
Off
Enables Network Time Protocol, which synchronizes the clocks of devices on a
network
Note: On is the factory default setting.
Understanding printer menus 107
To Next Page
Loading...
Need help?
General
