3 Left side 150 mm (5.9 in.)
4 Rear 100 mm (3.9 in.)
5 Top 150 mm (5.9 in.)
Printer configurations
CAUTION—TIPPING HAZARD: Floor-mounted configurations require additional furniture for stability. You must
use either a printer stand or printer base if you are using a high-capacity input tray, a duplex unit and an input
option, or more than one input option. If you purchased a multifunction printer (MFP) that scans, copies, and
faxes, you may need additional furniture. For more information, see www.lexmark.com/multifunctionprinters.
You can configure your basic printer by adding up to three 550‑sheet optional drawers and a 2,000‑sheet high‑capacity
feeder. A caster base and a spacer are supported in any configurations.
Spacers are nonfunctional trays used to add height to a printer stack. Spacers must be:
• Placed directly on a caster base or table top
• Placed at the bottom of all tray stacks, and cannot be used with an optional 2,000‑sheet high‑capacity drawer.
For information on installing a spacer, see the instruction sheet that came with the part.
1
2
3
4
6
7
9
5
8
1 Standard output bin
2 Paper support
3 Printer control panel
4 Optional 550-sheet specialty media drawer
5 Optional 550‑sheet drawer
6 Optional 2,000‑sheet high‑capacity feeder
7 Caster base
8 Standard 550‑sheet drawer (Tray 1)
9 Multipurpose feeder
Using C748x 81
To Next Page
Loading...
