Installing the trifold/Z‑fold finisher
CAUTION—SHOCK HAZARD: To avoid the risk of electrical shock, if you are accessing the controller
board or installing optional hardware or memory devices sometime after setting up the printer, then turn
the printer o, and unplug the power cord from the electrical outlet before continuing. If you have any
other devices attached to the printer, then turn them o as well, and unplug any cables going into the
printer.
Note: To install the trifold/Z-fold finisher, you must first install a booklet finisher.
1 Turn o the printer.
Set up, install, and configure 146
To Next Page
Loading...
