Notes:
• Do not slide paper into the tray.
• Make sure that the stack height is below the maximum paper fill indicator. Overfilling may cause
paper jams.
5 Insert the tray.
If necessary, set the paper size and type to match the paper loaded in the tray.
Note: When a
finisher
is installed, the images are rotated to 180° when printed.
Loading the 2000-sheet tray
CAUTION—TIPPING HAZARD: To reduce the risk of equipment instability, load each tray separately.
Keep all other trays closed until needed.
1 Pull out the tray, and then open the tray side door.
Note: To avoid jams, do not pull out trays while the printer is busy.
Set up, install, and configure 68
To Next Page
Loading...
