Configuration menus overview
71
Understanding the printer configuration menus
Auto LF after CR
Use this setting to: specify whether the printer automatically performs a line feed after a carriage
return control command.
Values:
Off (factory default)
On
Parallel menu
Use the Parallel menu to change printer settings on jobs sent through a parallel port.
NPA Mode
Use this setting to: send print jobs to the printer and query printer status information
simultaneously.
Values:
Off
On
Auto (factory default)
Protocol
Use this setting to: receive information at a much higher transmission rate if your printer is set to
Fastbytes (if your computer supports Fastbytes) or receive information at a normal transmission rate
if your printer is set to Standard.
Values:
Standard
Fastbytes (factory default)
Mode 2
Use this setting to: determine whether the parallel port data is sampled on the leading (On) or
trailing (Off) edge of strobe.
Values:
Off
On (factory default)
MAC Binary PS
Purpose: To configure the printer to process Macintosh binary PostScript print jobs.
To Next Page
Loading...
