Lexmark E360D series User Manual

An optional drawer attaches under the printer. A drawer consists of two parts: a tray and a support unit. The printer
supports one optional drawer; you can install a 250- or 550-sheet drawer.
CAUTION—SHOCK HAZARD: If you are accessing the system board or installing optional hardware or memory
devices sometime after setting up the printer, then turn the printer off, and unplug the power cord from the
wall outlet before continuing. If you have any other devices attached to the printer, then turn them off as well,
and unplug any cables going into the printer.
1 Unpack the drawer, and remove any packing material.
2 Remove the tray from the support unit.
1 Support unit
2 Tray
3 Remove any packing material and tape from inside the tray.
4 Insert the tray into the support unit.
5 Place the drawer in the location chosen for the printer.
Additional printer setup
20

Lexmark E360D series Specifications

General

Print Technology	Monochrome Laser
Print Resolution	1200 x 1200 dpi
Standard Memory	32 MB
Processor Speed	400 MHz
Print Speed	Up to 35 ppm
Input Capacity	250-Sheet Input Tray
Output Capacity	150 sheets
Media Types Supported	Plain Paper, Card Stock, Envelopes, Transparencies
Media Sizes Supported	Letter, legal, executive, A4, A5, B5, envelopes
Recommended Monthly Page Volume	750 to 3, 000 pages
Connectivity	USB 2.0
Print Languages	PCL 6, PostScript 3
Weight	14.0 kg
Supported Operating Systems	Windows, Linux, Mac OS X
Duplex Printing	Standard