Using the fax setup wizard in the printer
Notes:
• The setup wizard is available only if no device‑based fax, such as analog, etherFAX, or Fax over IP (FoIP),
is
configured.
• These instructions apply only to printers with 2.8‑inch touch‑screen display.
• Before using the wizard, make sure that the printer firmware is updated. For more information, see
“Updating firmware” on page 45.
1 From the home screen, touch Fax.
2 To uc h Set up now.
3 Type the fax name, and then touch Next.
4 Enter the fax number and then touch Done.
Using the Settings menu in the printer
1
From the control panel, navigate to:
Settings > Fax > Fax Setup > General Fax settings
For non-touch-screen printer models, press
to navigate through the settings.
2 Configure the settings.
Using the Embedded Web Server
1
Open a web browser, and then type the printer IP address in the address
field.
Notes:
• View the printer IP address on the home screen. The IP address appears as four sets of numbers
separated by periods, such as 123.123.123.123.
• If you are using a proxy server, then temporarily disable it to load the web page correctly.
2 Click Settings > Fax > Fax Setup > General Fax Settings.
3 Configure the settings.
4 Apply the changes.
Setting up the fax function using etherFAX
Notes:
• The printer firmware must be updated to the latest version. For more information, see “Updating
firmware” on page 45.
• An appropriate license bundle must be installed in your printer. For more information, contact etherFAX.
• Make sure that you have an etherFAX account. For more information, go to
https://www.etherfax.net/lexmark.
1 Open a web browser, and then type the printer IP address in the address
field.
Set up, install, and configure 24
To Next Page
Loading...
