2 Adjust the guide to match the size of the paper that you are loading.
3 Load a sheet of paper with the printable side faceup.
• Load letterhead with the printable side faceup and the top edge entering the printer first for one‑sided
printing.
• Load letterhead with the printable side facedown and the top edge entering the printer last for two‑sided
printing.
• Load envelope with the flap side down and against the left side of the paper guide.
Warning—Potential Damage: To avoid paper jams, do not force paper into the manual feeder.
Installing and updating software, drivers, and firmware
Installing the printer software
Notes:
• The print driver is included in the software installer package.
• For Macintosh computers with macOS version 10.7 or later, you do not need to install the driver to print
on an AirPrint-certified printer. If you want custom printing features, then download the print driver.
1 Obtain a copy of the software installer package.
• From the software CD that came with your printer.
• Go to www.lexmark.com/downloads.
2 Run the installer, and then follow the instructions on the computer screen.
Adding printers to a computer
Before you begin, do one of the following:
• Connect the printer and the computer to the same network. For more information on connecting the printer
to a network, see
“Connecting the printer to a Wi‑Fi network” on page 47.
• Connect the computer to the printer. For more information, see “Connecting a computer to the printer” on
page 50.
• Connect the printer to the computer using a USB cable. For more information, see “Attaching cables” on
page 22.
Note: The USB cable is sold separately.
Set up, install, and configure 44
To Next Page
Loading...
