Lexmark MB2236 - Page 32

Note: These instructions apply only to printers that support analog fax. For more information, see “Supported
fax” on page 23.
1 From the control panel, navigate to:
Settings > Fax > Fax Setup > Fax Receive Settings > Admin Controls > Answer On
For non-touch-screen printer models, press
to navigate through the settings.
2 Select a ring pattern.
Setting the fax date and time
Note: Make sure that fax is
configured.
For more information, see “Setting up the printer to fax” on page 23.
1 From the control panel, navigate to:
Settings > Device > Preferences > Date and Time > Configure
For non-touch-screen printer models, press
to navigate through the settings.
2 Configure the settings.
Configuring daylight saving time
Note: Make sure that fax is
configured.
For more information, see “Setting up the printer to fax” on page 23.
1 From the control panel, navigate to:
Settings > Device > Preferences > Date and Time > Configure
For non-touch-screen printer models, press
to navigate through the settings.
2 In the Time Zone menu, select (UTC+user) Custom.
3 Configure the settings.
Configuring
the fax speaker settings
Note: Make sure that fax is configured. For more information, see “Setting up the printer to fax” on page 23.
1 From the control panel, navigate to:
Settings > Fax > Fax Setup > Speaker Settings
For non-touch-screen printer models, press
to navigate through the settings.
2 Do the following:
• Set Speaker Mode to Always On.
• Set Speaker Volume to High.
• Enable Ringer Volume.
Set up, install, and configure 32