Lexmark MX321 - Saving Energy and Paper

• Always use the handholds on the printer to lift it.
• Any cart used to move the printer must have a surface able to support the full footprint of the printer.
• Any cart used to move the hardware options must have a surface able to support the dimensions of the
options.
• Keep the printer in an upright position.
• Avoid severe jarring movements.
• Make sure that your
fingers
are not under the printer when you set it down.
• Make sure that there is adequate clearance around the printer.
Note: Damage to the printer caused by improper moving is not covered by the printer warranty.
Shipping the printer
For shipping instructions, go to http://support.lexmark.com or contact customer support.
Saving energy and paper
Configuring
power save mode settings
Eco‑Mode
1
From the control panel, navigate to:
> Settings > > Device > > Power Management > > Eco‑Mode >
2 Select a setting.
Sleep mode
1
From the control panel, navigate to:
> Settings > > Device > > Power Management > > Timeouts > > Sleep Mode >
2 Enter the amount of time that the printer stays idle before it enters Sleep mode.
Hibernate mode
1
From the control panel, navigate to:
> Settings > > Device > > Power Management > > Timeouts > > Hibernate Timeout
>
2 Select the amount of time before the printer enters Hibernate mode.
Notes:
• Make sure to wake the printer from Hibernate mode before sending a print job.
• The Embedded Web Server is disabled when the printer is in Hibernate mode.
Maintaining the printer 124