Changing the fax resolution
1 Load an original document into the ADF tray or on the scanner glass.
2 From the control panel, navigate to:
> Fax > > enter the needed information >
3 Adjust the Resolution setting.
4 Fax the document.
Adjusting the fax darkness
1 Load an original document into the ADF tray or on the scanner glass.
2 From the control panel, navigate to:
> Fax > > enter the needed information >
3 Adjust the Darkness setting.
4 Send the fax job.
Viewing a fax log
Note: You may need administrative rights to view the fax logs.
1 Open a web browser, and then type the printer IP address in the address field.
Notes:
• View the printer IP address on the printer home screen. The IP address appears as four sets of
numbers separated by periods, such as 123.123.123.123.
• If you are using a proxy server, then temporarily disable it to load the web page correctly.
2 Click Settings > Reports > Fax.
3 Click Fax Job Log or Fax Call Log.
Blocking junk faxes
1 Open a web browser, and then type the printer IP address in the address field.
Notes:
• View the printer IP address on the printer home screen. The IP address appears as four sets of
numbers separated by periods, such as 123.123.123.123.
• If you are using a proxy server, then temporarily disable it to load the web page correctly.
2 Click Settings > Fax > Analog Fax Setup > Fax Receive Settings > Admin Controls.
3 Select Block No Name Fax.
4 Apply the changes.
Faxing 38
To Next Page
Loading...
