EasyManua.ls Logo

Lexmark MX910 Series - Page 232

Lexmark MX910 Series
363 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
1 Turn off the printer.
2 Open door C. Make sure that it does not hit any cable attached to the printer.
CAUTION—HOT SURFACE: The inside of the printer might be hot. To reduce the risk of injury from a hot
component, allow the surface to cool before touching it.
Note: If the 3000sheet tray is installed, then slide the tray to the right to open the door.
3 Remove the door stopper.
Maintaining the printer 232

Table of Contents

Related product manuals