EasyManua.ls Logo

Lexmark MX910 Series - Removing a Printer Hard Disk

Lexmark MX910 Series
363 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
7 Align the standoffs of the hard disk with the holes on the ISP, and then press the hard disk down until the standoffs
click into place.
8 Insert the plug of the hard disk interface cable into the connector on the ISP, and then connect the ISP solution
interface cable into the receptacle of the controller board.
Removing a printer hard disk
Note: Use the screwdriver located inside the bottom front door of the printer.
Additional printer setup 36

Table of Contents

Related product manuals